Articles:

Depending on the problem you're trying to address, you can set the level of the size of the Chip to the level that is appropriate to your analysis.

And nowhere is this more relevant than in data centre design.. A data centre is about performance above all – minimising cost per kW, maximising IT yield per square metre, minimising energy and water consumption, maximising the efficiency of M&E building services, and minimising waste..There are standard ways to address all of these value drivers, and many companies to do that.

But to really raise the bar on what can be achieved with data centre design and M&E services, it’s essential to understand the mechanical and electrical systems, the architecture and the structure as being intimately interconnected and fully interdependent.Each of these facets must work in harmony to maximise the potential for optimal data centre design and that is impossible to do when the project is divided up and these areas are treated separately..It is, however, possible to achieve through an integrated design approach and.

Data centres developments have baseline costs like utilities, land, civils and structure...So the more data centre capacity you can fit onto your site, the more IT yield per square metre you will get, and the lower your cost per kW will be.. As data centre designers, we must aim to maximise the site yield.

Here’s how we can do this:.

It is not uncommon for permitted development on data centre sites to be limited to around 20 metres .These include transportation (a pre-fabricated room is mostly air, after all) and heavy plant for lifting modules into place.

Unless modules are fabricated on a just-in time basis they also have to be stored which costs money, especially if that storage needs to be sheltered from the elements.3D modules also occupy large amounts of factory floor space and therefore absorb a high proportion of factory overheads..

If these additional modular construction costs can be offset by large improvements in construction site efficiency, for example by relocating wet trades or complex specialist trades away from the site, a 3D module might make sense.But, with modular construction, it’s often the case that prefabricating comparatively simple parts of a building as 3D modules adds cost and complexity, especially if the required trades need to be present on-site anyway..